RESUMO
Aim: This study aimed to know the potential of diode light amplification by stimulated emission of radiation (LASER) and desensitizing agents on blocking the dentinal tubules, which may further help in reducing the most common dental problem named dentinal hypersensitivity (DH). Materials and Methods: Sixty human permanent bicuspids were selected, and preparation was performed in the cervical region measuring 2.5 mm × 2.5 mm × 2.5 mm, followed by acid etching for 15 seconds. These are then divided according to the groups mentioned: group 1-nano-hydroxyapatite (HA) was applied for 15 minutes; group 2-biosilicate was applied for 15 minutes; group 3-diode LASER application was performed twice for 60 seconds in noncontact mode; group 4-nano-HA plus diode LASER application; and group 5-biosilicate plus diode LASER application. The same procedure was followed on the 1st, 7th, and 14th days and then rinsed and stored in artificial saliva, and the saliva was changed every 24 hours. The dentinal tubular occlusion was observed under a scanning electron microscope (SEM) after the 14th day. Result: The maximum dentinal tubular occlusion was observed in group 4, where nano-HA and diode LASER application was performed. Conclusion: All the investigated treatment groups have promising occluding potential, but the maximum was found in group 4 >group 5 >group 3 >group 1 >group 2. LASER plus desensitizing together prove to be potent and effective in reducing dentinal tubular diameter.
RESUMO
Aim: To compare the healing following various maxillofacial incisions using 2-octyl cyanoacrylate (2-OCA) and prolene (4-0) sutures. Objective: To evaluate the complications and aesthetic outcome of the incision wounds after closure using 2-OCA and prolene (4-0) sutures. Materials and Methods: The patient undergoing an extraoral incision was evaluated for pain, inflammation, infection, dehiscence, scar, and surface texture. In Group I, 15 patient incisions were closed with 2-OCA and in Group II, 15 patient incisions were closed with prolene (4-0) suture. Result: A few patients experienced pain with Group I and then Group II, but infection, inflammation, and dehiscence were more in Group I than in Group II. Conclusion: A cosmetic outcome was higher in the cyanoacrylate group, and the surface texture was satisfying in the same group.
RESUMO
AIM: To estimate the working length of teeth using conventional tactile technique, radiovisiography technique, Apex locator, and confirmation of working length by cone beam computed tomography technique. MATERIALS AND METHODS: Forty patients with the age group between 20 and 50 years with irreversible pulpitis were included in this study. After taking a preoperative radiograph, the procedure was started. The cavity wall buildup was done using composite in the cases needed and then rubber dam application was done. The working length of mesiobuccal and mesiolingual canal was taken using cone beam computed tomography and this was considered as the standard value. Then using tactile method, length of the canal was measured using radiovisiographic software followed by apexlocator. RESULT: The Apex locator has showed best result as compared to tactile and radiovisiography. CONCLUSION: Apex locator values were closest to cone beam computed tomography working length measurement values and electronic apexlocator can be used efficiently as an alternative method for working length determination. The quality of various techniques according to ranks of working length determination was found to be Cone beam computed tomography (CBCT) > Apexloc > Radiovisiography (RVG) > Tactile. Thus, Apex locator can be used as an alternative to cone beam computed tomography for working length determination.
